Home \ Help \ Search \ Login RSS

Welcome, Guest. Please Login

This forum is now READ-ONLY! Please visit http://forum.wiring.co/ for the new forum.

Wiring ForumProgramming Questions & HelpIntegration › Difficulty uploading from wiring to board

Page Index Toggle Pages: 1
Difficulty uploading from wiring to board (Read 3194 times)
11/23/08 at 14:27:53

Florian SIGMA6   Offline
YaBB Newbies
Geneva

Posts: 8
*
 
Hello everyone, i'm having some difficulty uploading from wiring to the board, i seems to work only 1 out of 20 try. Maybe i'm doing something wrong but i just can get what: I write my code, i verify it, then i hit the reset buton on the board, and than i click on the upload...
Then when i recived the message:
Atmel AVR ATmega128 is found.
Uploading: flash
Firmware Version: 1.15
Firmware Version: 1.15

i hit the board reset button again, and it almost never works...
Thanks
 

Florian | SIGMA6
IP Logged
 
Reply #1 - 11/23/08 at 14:38:49

Titus   Offline
Full Member
Wiring Soccer Robot!
Amsterdam

Posts: 176
***
 
Well, according to the message you received the program loaded like it should.
Could you post your code? Perhaps you made a mistake somewhere and therefore it won;t act like you expect...?
 

Check www.TeamVossius.nl for our Autonomous soccer robots!
IP Logged
 
Page Index Toggle Pages: 1