Home \ Help \ Search \ Login RSS

Welcome, Guest. Please Login

This forum is now READ-ONLY! Please visit http://forum.wiring.co/ for the new forum.

Wiring ForumWiring HardwareTroubleshooting › Problem uploading

Page Index Toggle Pages: 1
Problem uploading (Read 3648 times)
07/12/08 at 23:58:03

elemak   Offline
YaBB Newbies
I Love YaBB 2!

Posts: 2
*
 

Hi I have the following problem:
After selected the serial port, I try to upload an example (potentiometer) but it says:
"Device is not responding, check the right serial port is selected or RESET the board right before exporting"

There is only one serial port in the menu and it's selected, I pushed RESET many times and nothing happened. I think is the same problem as seen in:
    http://wiring.org.co/cgi-bin/yabb/YaBB.pl?num=1136300249

This is my first time with a Wiring Card, I think I haven't  missed up any step in the setup.

Anyone can help me? Any suggestions?

Thanks Sad
 
IP Logged
 
Reply #1 - 07/14/08 at 00:50:58

barragan   Offline
YaBB Administrator

Posts: 939
*****
 
If the drivers were installed properly then the problem must be in steps 3 or 4 of the setup http://wiring.org.co/hardware/software_setup.html
Check what´s on the serial menu before plugin the wiring board and check again after plugin a new serial must be added to the menu when the wiring baord is present. If not then you need to go back and install the drivers.
 
IP Logged
 
Reply #2 - 07/16/08 at 21:40:48

elemak   Offline
YaBB Newbies
I Love YaBB 2!

Posts: 2
*
 
Hi
It seems the problem dissapeared...I guess it was because I reseted many times my computer (I'm not sure), and suddenly it worked.

Anyway, thanks for your help.

 
IP Logged
 
Page Index Toggle Pages: 1