Home \ Help \ Search \ Login RSS

Welcome, Guest. Please Login

This forum is now READ-ONLY! Please visit http://forum.wiring.co/ for the new forum.

Wiring ForumProgramming Questions & HelpSyntax › OT? controller boards

Page Index Toggle Pages: 1
OT? controller boards (Read 2959 times)
08/18/07 at 19:04:24

solidox   Offline
YaBB Newbies

Posts: 2
*
 
Hi,

I want to built a smallish gyrobot and for that I'm looking at three controllers: make, arduino, and wiring.

I like the physical simplicity of the MAKE board, and fact that you can connect things directly without the need for resistors, motor driver chips, etc (most of the time).

Now, what I understand is that the only way to run independent projects on the MAKE board without the need of a computer controlling it is by writing your own C code, running it through the toolchain and finally uploading it. If that's that's case, I'll stick to one of the other two since I prefer the wiring/arduino enviroment.

Is there any way I can use Wiring on the Make board ? I'm guessing there isn't since it's a different chip but I want to be sure.


Cheers
 
IP Logged
 
Reply #1 - 08/20/07 at 04:13:54

barragan   Offline
YaBB Administrator

Posts: 939
*****
 
hi, it is a different system so right now it´s not possible.
 
IP Logged
 
Page Index Toggle Pages: 1