Home \ Help \ Search \ Login RSS

Welcome, Guest. Please Login

This forum is now READ-ONLY! Please visit http://forum.wiring.co/ for the new forum.

Wiring Forum › Wiring Hardware › How to get it? › Bootloading question

(Moderators: bhagman, barragan)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Bootloading question (Read 4196 times)
02/14/07 at 17:02:53
jamesTichenor   Ex Member

 
I wanted to use an avrisp to burn the probram onto the board without the 6 second startup delay.

I had done this with arduino with an AVRISP mkII and avr studio.

but my question is a confusion about pins. the output of the AVRISP mkII has 6 pins but there are 10 on what looks to be the ISP part of the wiring board.

Any advice. I had seen some post where people used and AVRISP to write to the chip. but im confused if there is a differnece between the AVRISP and the AVRISP mkII.. I thought maybe that was the problem and when i thought i was ordering the regular (from digikey) one i got the mkII so maybe is simply replaced the other?
 
Back to top 
IP Logged
 
Reply #1 - 02/15/07 at 04:48:33

barragan   Offline
YaBB Administrator

Posts: 939
 *****
 
hi James, well there are 2 versions of the ISP connector as you said 6 and 10 pin, the avrisp has the two type of connectors, and it comes with the 2 cables (6 and 10pins) so you can exchange the cable and use the appropriate.
I'll check on the differences with the one you are mentioning.
 
Back to top 
IP Logged
 
Page Index Toggle Pages: 1
‹ Previous Topic | Next Topic ›