Wiring Forum
http://wiring.org.co/cgi-bin/yabb/YaBB.pl
Wiring Hardware >> Troubleshooting >> Problem uploading
http://wiring.org.co/cgi-bin/yabb/YaBB.pl?num=1215907084

Message started by elemak on 07/12/08 at 23:58:03

Title: Problem uploading
Post by elemak on 07/12/08 at 23:58:03

Hi I have the following problem:
After selected the serial port, I try to upload an example (potentiometer) but it says:
"Device is not responding, check the right serial port is selected or RESET the board right before exporting"

There is only one serial port in the menu and it's selected, I pushed RESET many times and nothing happened. I think is the same problem as seen in:
   http://wiring.org.co/cgi-bin/yabb/YaBB.pl?num=1136300249

This is my first time with a Wiring Card, I think I haven't  missed up any step in the setup.

Anyone can help me? Any suggestions?

Thanks :(

Title: Re: Problem uploading
Post by barragan on 07/14/08 at 00:50:58
If the drivers were installed properly then the problem must be in steps 3 or 4 of the setup http://wiring.org.co/hardware/software_setup.html
Check what´s on the serial menu before plugin the wiring board and check again after plugin a new serial must be added to the menu when the wiring baord is present. If not then you need to go back and install the drivers.

Title: Re: Problem uploading
Post by elemak on 07/16/08 at 21:40:48
Hi
It seems the problem dissapeared...I guess it was because I reseted many times my computer (I'm not sure), and suddenly it worked.

Anyway, thanks for your help.


Wiring Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.