Wiring Forum
http://wiring.org.co/cgi-bin/yabb/YaBB.pl
Suggestions >> Software Suggestions >> OSC firmware from d.tools
http://wiring.org.co/cgi-bin/yabb/YaBB.pl?num=1154005454

Message started by mellis on 07/27/06 at 13:04:14

Title: OSC firmware from d.tools
Post by mellis on 07/27/06 at 13:04:14
In response to the previous topic (which I don't seem to be able to reply to), the d.tools folks have created an OSC firmware for Wiring: http://hci.stanford.edu/dtools/wiring.html

It lets you address the various pins as OSC addresses, etc.

Title: Re: OSC firmware from d.tools
Post by uwa_ir on 02/22/07 at 00:32:54
hi mellis!

i was reading how to install the d.tools but got a bit afraid of continuing since im on os x and it seems it was all developed and tried under windows.

on the other hand i will like to know if the library that comes in the arduino ethernet board that says handles OSC can be ported to wiring?

also, i read that the MAKE controller board has already OSC implemented. I hope to get feedback from people actually using this protocol.

else i might try the SMS that someone mentioned in the forums.

/a

Title: Re: OSC firmware from d.tools
Post by barragan on 02/22/07 at 08:09:32
It should work fine under OS X, the uisp command mentioned in the tutorial (http://hci.stanford.edu/dtools/wiring.html) is included with the Wiring distribution, you can find it in the wiring-00XX/tools/avr/bin directory.

Wiring Forum » Powered by YaBB 2.5 AE!
YaBB Forum Software © 2000-2010. All Rights Reserved.